Segger J-Link User Manual page 238

Hide thumbs Also See for J-Link:
Table of Contents

Advertisement

238
5.12.1.55 SetRestartOnClose
This command specifies whether the J-Link restarts target execution on close. The
default is to restart target execution. This can be disabled by using this command.
Syntax
SetRestartOnClose = 0 | 1
Example
SetRestartOnClose = 1
5.12.1.56 SetRTTAddr
In some cases J-Link cannot locate the RTT buffer in known RAM. This command is
used to set the exact address manually.
Syntax
SetRTTAddr <RangeStart>
Example
SetRTTAddr 0x20000000
5.12.1.57 SetRTTTelnetPort
This command alters the RTT telnet port. Default is 19021.
This command must be called before a connection to a J-Link is established.
In J-Link Commander, command strings ("exec <CommandString>") can only be exe-
cuted after a connection to J-Link is established, therefore this command string has
no effect in J-Link Commander. The
used instead .
Syntax
SetRTTTelnetPort <value>
Example
SetRTTTelnetPort 9100
5.12.1.58SetRTTSearchRanges
In some cases J-Link cannot locate the RTT buffer in known RAM. This command is
used to set (multiple) ranges to be searched for the RTT buffer.
Syntax
SetRTTSearchRanges <RangeAddr> <RangeSize> [, <RangeAddr1> <RangeSize1>, ..]
Example
SetRTTSearchRanges 0x10000000 0x1000, 0x20000000 0x1000,
5.12.1.59SetRXIDCode
This command is used to set the ID Code for Renesas RX devices to be used by the J-
Link DLL.
Syntax
SetRXIDCode = <RXIDCode_String>
Example
Set 16 IDCode Bytes (32 Characters).
J-Link / J-Trace (UM08001)
CHAPTER 5
command line parameter can be
-RTTTelnetPort
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG
Working with J-Link and J-Trace

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the J-Link and is the answer not in the manual?

This manual is also suitable for:

J-trace

Table of Contents

Save PDF