Segger J-Link User Manual page 154

154
-SetPowerTarget <Mode>
Example
JLinkSTM32.exe -SetPowerTarget 1
-SetDeviceFamily
This command allows to specify a device family, so that no user input is required to
start the unlocking process.
Syntax
-SetDeviceFamily <Parameter>
Parameter
There are two different options to specify the device family to be used:
a) Pass the list index from the list which shows all supported familys on start up
b) Pass the defined device name
ListIndex
1
2
3
4
5
6
Table 3.17: Available Parameter for -SetDeviceFamily
Example
JLinkSTM32.exe -SetDeviceFamily 6
JLinkSTM32.exe -SetDeviceFamily STM32L1xxxx
-Exit
In general, the J-Link STM32 utility waits at the end of the unlock process for any
user input before application closes. This option allows to skip this step, so that the
utility closes automatically.
Syntax
-Exit <Mode>
Example
JLinkSTM32.exe -Exit 1
J-Link / J-Trace (UM08001)
CHAPTER 3
Name
STM32F0xxxx
STM32F1xxxx
STM32F2xxxx
STM32F3xxxx
STM32F4xxxx
STM32L1xxxx
// J-Link STM32 utility closes automatically
J-Link software and documentation package
// Target power will be set
// Selects STM32L1 series
// Selects STM32L1 series
© 2004-2017 SEGGER Microcontroller GmbH & Co. KG