Parameters, Record, Interfaces - Dräger Cato Instructions For Use Manual

Parameters
The settings for the following parameters are defined via
this menu:
– SpO -measurement
2
– sidestream
measurement O
2
– sample rate
– CO units
2
Record
This menu is used to define which event triggers an
automatic entry in the record list or printout on the
on-line printer:
– time intervall Entry upon expiry of a fixed time
interval in minutes.
– NiBP started Entry after every NiBP
measurement with new results.
– warning started Entry is made whenever a warning
has been triggered.
– caution started Entry is made whenever a caution
has been triggered.
Interfaces
The interface for data transfer (Dräger MEDIBUS RS 232)
and the printer port are configured here:
– baud rate Transmission rate (can be varied,
see Instructions for Use of the device
to be connected)
– parity Cannot be changed in MEDIBUS and
is merely displayed for information.
– data bits Cannot be changed in MEDIBUS and
is merely displayed for information.
– stop bits Cannot be changed in MEDIBUS and
is merely displayed for information.
– protocol Allows the printer port to be used as
a second MEDIBUS interface.
on • off
on • off
60 • 200 mL/min
mmHg • kPa • % by volume
Configuring monitor functions in »standby«
Standby / Configuration
anaesth. gas warning calibrating
SpO - measure.
on off
2
sidestream
measurement O
on off
2
sample rate
60 200 mL/min
CO units
mmHg kPa Vol%
2
Standby / Configuration
anaesth. gas
warning calibrating
list entry
time
1 2 5 10
intervall
NiBP started
on off
warning started
on off
caution started
on off
printer entry
time
1 2 5 10
intervall
NiBP started
on off
warning started
on off
caution started
on off
Standby / Configuration
anaesth. gas
warning calibrating
RS 232 (Medibus) :
baud rate
1.2 9.6
parity
even
data bits
8
stop bits
1
record (printer)
protocol
printer Medibus
baud rate
1.2 2.4 4.8 9.6
parity
odd even
data bits
7 8
stop bits
1 2
Monitor functions

Parameters, Record, Interfaces

Alarms inactive!
defaults
pulse to.
0 1 2 3 4 5 6 7 8 9
alarm tone
1 2 3 4 5 6 7 8 9
mode
adult Neo.
parameters
record
interfaces
alarm limits
curves
basic configuration
Menu for configuration
of measurement-parameters.
Alarms inactive!
defaults
pulse tone
0 1 2 3 4 5 6 7 8 9
off
alarm tone
1 2 3 4 5 6 7 8 9
mode
adult Neo.
parameters
record
interfaces
alarm limits
off
curves
basic configuration
Menu for configuration
of list and print entries.
Alarms inactive!
defaults
pulse tone
0 1 2 3 4 5 6 7 8 9
alarm tone
1 2 3 4 5 6 7 8 9
mode
adult Neo.
parameters
record
interfaces
alarm limits
curves
19.2
basic configuration
none
Menu for configuration
of Medibus and printer
ports.
53