Ippv; Selecting Ippv Mode; Adjusting Ventilation Parameters - Dräger Cato Instructions For Use Manual

IPPV

Selecting IPPV mode

Secretion aspirator may only be used in
[
»MAN/SPONT« mode or with disconnected
Y-piece.
After switching on, the ventilation parameters set prior to
delivery or subsequently programmed by DrägerService
are active in IPPV mode.
1 Set the values required for the patient.
Default settings upon delivery of new equipment:
(may be altered by DrägerService if requested by
customer)
V Tidal volume
T
f IPPV frequency
IPPV
P Maximum ventilation pressure
max
T :T Inspiration/expiration time ratio
I E
T :T Inspiration pause/inspiration
IP I
time ratio
2 Set PEEP – if necessary.
3 Press »IPPV«.
4 Display in dialogue field:
IPPV Mode ?
5 Press rotary control to confirm –
ventilation starts.
The parameters Pmax, V
movement are displayed on the ventilator.
The monitor is also started and the IPPV alarm limits
are activated.
Adjusting ventilation parameters (P
6 Press »P «.
max
1 The set value appears in the window above, while
4 the set value (left), the parameter and its unit of
measure (middle) and the value to be adjusted (right)
appear in the dialogue window.
5 Turn rotary control:
4 the value on the right changes –
5 continue turning until the required maximum pressure
is reached. Press rotary control to confirm this value –
1 the new value is displayed –
if the new value is not confirmed, it will not be
adopted by the system and the display disappears
after approx. 10 seconds.
f , V , T :T , T :T , PEEP and fIMV are adjusted
IPPV T I E IP I
like P after pressing the corresponding parameter
max
key.
0.6 L
12 breaths/min.
25 mbar
1 : 1.7
10 %
, f , PEEP and piston
T IPPV
for example):
max
3
1
IPPV alarm limits
CO
2
40
20
0
PAW
20
0
1
6
Operation
IPPV
Selecting IPPV mode
4
5
2
98 67
SpO
alarm
2
limits
38
auto set
etCO
2
vent. al.
6.0 10
MV freq
alarm
info
Fi Fet
list
29 25
O 18
2
curve
0.8 0.6
Hal.
70 68
config.
N O
2
4
5
39