Ippv - Dräger Evita 2 dura Instructions For Use Manual

Operation
Setting Ventilation Modes
To prevent settings being changed inadvertently:
1 Press the » « key. Its yellow LED will light up. The
parameter keys and ventilation mode keys will be protected
against inadvertent setting.
Before setting a new value:
1 Press the » « key. The yellow LED will go out.

IPPV

Intermittent Positive Pressure Ventilation
Volume-controlled ventilation with a fixed mandatory minute
volume MV, set with the tidal volume V
For patients unable to breathe spontaneously.
Set ventilation pattern for IPPV via the keys for the ventilation
parameters:
Tidal volume »V «
T
Insp. Flow »Flow«
Frequency »f«
Inspiration time »T «
insp
O concentration »O «
2 2
Positive end-expiratory pressure »PEEP«
IPPV can be supplemented by the following ventilation
parameters:
Trigger (IPPV ) – for synchronising mandatory ventilation
Assist
with attempted spontaneous breathing by the patient. By
activating the trigger and setting the trigger sensitivity, the
mandatory ventilator strokes are synchronised with the
patient's spontaneous breathing attempts.
The trigger can be switched off if synchronisation with the
patient's spontaneous breathing attempts is not required.
To activate/set:
●
Press ventilation parameter key »Trigger«.
●
Set value = turn the rotary knob,
Confirm value = press the rotary knob.
To deactivate:
●
Set a value less than 0.3 or above 15 L/min.
The display will show: – – –
42
and frequency f.
T
D
Paw
Insp.
pause
P
plat
T T
insp e
1
f
Flow
Insp. Flow
Evita 2 dura
1
t
t