Honda Civic 1998 Service Manual page 166

13. Check the housing-to-outer rotor radial clearance.
It the housing-to-outer rotor radial clearance exceeds
the servjce limit, replace the set of inner and outer
rotors and/or the pump housing
Hoqsing.to.Outor Botor Radial Clearance:
Standard {New): 0.10 - 0.18 mm
(0.004 - 0.007 in)
Service Limit:
0.20 mm (0.008 in)
HOUSING
Inspect both rotors and the pump housing for scor-
ing or other damage. Replace parts if necessary.
Remove the old oil seal from the oil pump.
Using the special tool, gently tap in the new oil seal
until the driver bottoms against the pump.
NOTE: The oil seal alone can be replaced without
removing the oil pump.
DRtvER
0?7i19 - 0010000
1 4 .
1 5 .
t o .
ATTACHMENT.
5 2 x 5 5 m m
07746 - 0010i100
1 8 .
1 9 .
20.
2 1 .
' 1 7 . R e a s s e m b l e t h e
o i l p u m p , a p p l y i n g t h r e a d l o c k t o
the pump housing screws.
Check that the oil pump turns treely.
Apply a light coat of oil to the seal lip.
Install the two dowel pins and new O-ring on the oil
p u m p .
Apply liquid gasket to the cylinder block mating sur-
face of the oil pump.
NOTE:
. Use liquid gasket, Part No. 08718 - 0001 or 08718
- 0003
. Check that the mating surfaces are clean and dry
before applying liquid gasket.
. Apply liquid gasket evenly, in a narrow bead cen
tered on the mating surface.
. To prevent oil leakage, apply liquid gasket to the
inner threads of the bolt holes.
. Do not install the pans if five minutes or more
h a v e e l a p s e d s i n c e a p p l y i n g l i q u i d g a s k e t .
Instead reapply liquid gasket after removing the
old residue.
. After assembly, wait at least 30 minutes before
filling the engine with oil.
(cont'd)
Apply liquid gasket
along the broken line.
8 - 1 1