Process Value (Circular Plug M 8); Option: With Temperature Sensor Input (3 Circular Plugs M8) - Burkert 8630 Operating Instructions Manual

I
NSTALLATION

Process value (circular plug M 8)

Input type *
4 ... 20 mA
- internal
supply
4 ... 20 mA
- external
supply
Frequency
- internal
supply
Frequency
- external
supply
Pt-100
(see
Note
below)
* May be set via software (section Procedure for specifying the basic settings )
The jumper is situated on the connection board of the TOP Control Continuous (see next page)
**
NOTE For line compensation reasons, connect sensor Pt-100 via 3 conductors. PIN 3 and PIN 4
must be bridged at the sensor.
Process value with the option flow rate controller (2 circular plugs M8)

Option: with temperature sensor input (3 circular plugs M8)

Input type No. of
plugs
internally
supplied
transmitter*
Option:
temperature
transmitter
* With external supply of the sensors, the mass of the standard signal must be
connected to the mass of the supply voltage.
46 - 8630
Pin Allocation
1 + 24 V supply transmitter
2 Output Transmitter
3 GND
4 bridge to GND (GND from
3-conductor transmitter)
1 not connected
2 Process actual +
3 not connected
4 Process actual -
1 + 24 V - supply sensor
2 Clock input +
3 Clock input - (GND)
4 not connected
1 not connected
2 Clock input +
3 Clock input -
4 not connected
1 not connected
2 process actual 1(current supply)
3 process actual 3 (GND)
4 process actual 2 (compensation)
Pin Configuration
1 1 + 24 V - supply to transmitter p1
2 4 ... 20 mA - output from transmitter p1
3 + 4 n.c.
2 1 + 24 V - supply to transmitter p2
2 4 ... 20 mA - output from transmitter p2
3 + 4 n.c.
3 1 + 24 V - supply to transmitter
2 4 ... 20 mA - output from temperature
transmitter
3 + 4 n.c.
Jumper** External connection
2
4
1
2
3
2
3
2
3
4
Jumper ext. connection
Circular plug
M12
4 ... 20 mA
GND
+24 V
Clock +
Clock -
Clock +
Clock -
Pt 100