Explanation Of The Menu Items; Functional Deviations From The Standard Version - Burkert 8630 Operating Instructions Manual

P DP
ROFIBUS

Explanation of the menu items

BUS ADDR
ADDR xxx
BUS PDI
* PDI. POS
:
* PDI. ERR
BUS PDO
* PDO. INP
:
* PDO. ERR
BUS FAIL
SPOS OFF
SPOS ON

Functional deviations from the standard version

The operating mode can be switched between MANUAL and AUTOMATIC in the process operating level
either with the keypad on the TOP Control Continuous or over the bus.
MANUAL/AUTOMATIC switchover on the keypad is no longer possible when an operating mode (under
"PDO MODE" ) is transmitted to the TOP Control Continuous over the bus.
124 - 8630
Entry of the device address (default: 3)
Values from 0 to 126 can be set with the arrow keys;
confirmation is done with the MANUAL/AUTOMATIC key.
Selection of the process values that are to be transferred from the TOP Control
Continuous to the control (master).
with the MANUAL/AUTOMATIC key, each process value can be either
activated (* appears) or deactivated (no * )
For significance of the process values, see table PDI: Process Data Input
Selection of the process values that are to be transferred from the control
(master) to the TOP Control Continuous.
With the MANUAL/AUTOMATIC key, each process value can be either
activated (* appears) or deactivated (no * ).
For significance of the process values, see table PDO: Process Data Output
Activation for movement to saftey position on bus communication failure
The actuator moves to the position corresponding to the setpoint last transmitted
(default setting).
With SPOS ON set, the following configurations can occur:
Activated menu item SAFEPOS
On error in bus communication, the actuator moves to the position set under
SAFEPOS .
Deactivated menu item SAFEPOS
On error in bus communication, the actuator moves to the end position it would
occupy in the zero voltage condition.