Operating Mode Automatic; Meaning Of The Keys; Displays; Operating Structure And Procedures - Burkert 8630 Operating Instructions Manual

Operating mode AUTOMATIC

In the AUTOMATIC mode, normal controlled operation is executed and monitored.

Meaning of the keys

or
or
> 3 sec
and

Displays

With the process controller activated, the following parameters can be displayed:
• Actual value of process variable (process value)
• Setpoint of process variable (process setpoint)
• Setpoint position of valve actuator after rescaling through
optionally activated split-range function or correction curve
• Temperature inside housing of the TOP Control Continuous
By pressing the arrow keys, you can switch between these display options.

Operating structure and procedures

AUTOMATIC
mode
PV_____
SP_____
Switch over
POS__XXX
display
CMD __XXX
TEMP__XX.X
MANUAL
mode
If the device is in the safety position (for the relevant configuration, see menu item BIN-IN
NOTE
or SIG-ERR), SAFE XXX appears in the display.
If the menu item CUTOFF is activated and the process vave is in the tight-closing range,
a flashing MIN or MAX symbol appears in the display.
If the process value ( PV ) is above or below the measurement range, a flashing bar
appears in the display.
Switch over the display
Change the process setpoint
With configured supplementary functions P.CONTRL/P.CO SETP/SETP INT
and SP display set.
Make P.TUNE (process tune) ready for start.
With PID self-optimization activated, P.CONTRL/P.CO TUNE/ P.TUN ACT
Configuration
Menu item
(> 5 s)
No
operating
action
or
Release key
O
PERATING THE PROCESS CONTROLLER
PV_____ (- 999 ... 9999)
SP_____ (- 999 ... 9999)
CMD __XXX (0 ...100 %)
TEMP__XX.X (in °C)
P.TUNE
(process tune)
ready for start
END
and
Set the
process
SP
setpoint
or
active
(> 3 s)
P.TUNE
(process tune)
Release
key
8630 - 113