Configuration Example 2 - Burkert 8630 Operating Instructions Manual

D N
EVICE ET

Configuration example 2

This example describes the basic procedure for setting-up the process mapping of a DeviceNet Master /
Scanner, using the software RSNetworx for DeviceNet (Rev. 2.11.51.0).
Setting-up the Scanlist and setting the I/O parameters
First of all the Scanlist of the DeviceNet Master / Scanner is set-up. For this the devices listed in the left
hand part of the associated window are transferred to the right hand part of the window. Then a change
of the I/O parameters can be carried out for each device transferred to the Scanlist. This is necessary
when, on configuring the relevant TOP Control Continuous, Assemblies have been selected which differ
from the default settings.
Shown in the figure is the setting of the I/O parameters with selected
Input-Assembly
Output-Assembly
148 - 8630
POS + CMD + ERR (5 bytes long) and selected
INP (2 bytes long; default-Assembly - no change required).