Operating Mode Automatic; Meaning Of The Keys In The Automatic Mode; Display Of The Automatic Mode - Burkert 8630 Operating Instructions Manual

Operating mode AUTOMATIC

(yellow LED flashes)
In the AUTOMATIC mode, normal controlled operation is executed and monitored.

Meaning of the keys in the AUTOMATIC mode:

or
or
> 3 s

Display of the AUTOMATIC mode

With regard to the positioner, the following parameters can be displayed:
• Actual position of valve actuator
• Setpoint position of valve actuator after rescaling through optionally
activated split-range function or correction characteristic:
• Input signal for setpoint position:
• Temperature inside housing of TOP Control Continuous
By pressing the arrow keys, you can switch between these 4 display options.
If the device is in the safety position (for the relevant configuration, see menu item BIN-IN
NOTE
or SIG-ERR), SAFE XXX appears in the display.
If the menu item CUTOFF is activated and the process vave is in the tight-closing range,
a flashing MIN or MAX symbol appears in the display.
Switch over the display
Change the process setpoint:
with configured supplementary functions P.CONTRL / P.CO SETP / SETP INT
and display set to SP
AUTOMATIC mode
or
Switch over
display
Release key
MANUAL mode
O
PERATION AND
POS__XXX (0 ... 100 %)
CMD__XXX (0 ... 100 %)
INP__XXX
(0 ... 5/10 V or 0/4 ... 20 mA)
TEMP_XX.X (in °C)
Configuration
Menu item
END
(> 5 sec.)
No operating
action
C F
ONTROLLER UNCTIONS
8630 - 87