Configuration In The Profibus Dp Master; Configuration In The Profibus Dp Master; Configuration Of The Process Values - Burkert 8630 Operating Instructions Manual

Configuration in the PROFIBUS DP master

User parameters (hex paramaters) are not required.

Configuration of the process values

First the process data input are entered (from the TOP Control Continuous to the control).
NOTE
PDI : Process Data Input
(from the TOP Control Continuous to the control)
Name Description
PDI:POS Actual position (Position)
Actual value of positioner in ‰.
Range of values 0 ... 1000.
Values < 0 or > 1000 are possible when e.g.
AUTOTUNE was not run throug properly.
Setpoint position (Command)
PDI:CMD
Positioner setpoint in ‰. Range of values 0 ... 1000.
Process actual value (Process Value)
PDI:PV
Actual value of process controller in physical units
(as set in menu P.CO INP or P.CO SCAL), max.
range of values -999 ... 9999, depending on internal
scaling
PDI:SP Process setpoint (Setpoint)
Setpoint of value of process controller in physical units
(as set in menu P.CO INP or P.CO SCAL), max. range
of values -999 ... 9999, depending on internal scaling
Device temperature (Temperature)
PDI:TEMP
Temperature in 0.1 °C is measured on the CPU board
with a sensor,
range of values -550 (-55 °C) ... +1250 (+125 °C)
PDI:MODE Operation mode (Operation Mode)
Operation mode:
0: AUTO
1: HAND
2: XTUNE
3: MENUE
9: P.QLIN
PDI:ERR Error (Error)
States the number of the process value (output) that
was not written. The value is retained until deleted with
PD-O:ERR.
HEX
14 PD-O:CMD
15 PD-O:SP
16 PD-O:MODE
In the same order as in the selection in the TOP Control Continuous and only process
data ( PDI ) activated in the configuration menu may be entered.
10: P.TUNE
12: BUSSAFEPOS
P
ROFIBUS
Identifiers
GSD file: PDI:POS
Identifiers (HEX): 41, 40, 00
GSD file: PDI:CMD
Identifiers (HEX): 41, 40, 01
GSD file: PDI:PV
Identifiers (HEX): 41, 40, 02
GSD file: PDI:SP
Identifiers (HEX): 41, 40, 03
GSD file: PDI:TEMP
Identifiers (HEX): 41, 40, 04
GSD file: PDI:Mode
Identifiers (HEX): 41, 00, 05
GSD file: PDI:ERR
Identifiers (HEX): 41, 00, 06
8630 - 125
DP