Operating The Process; Changeover Between The Operating Modes - Burkert 8630 Operating Instructions Manual

O
PERATING THE PROCESS CONTROLLER

Operating the process

Each time after switching on the voltage supply, the TOP Control Continuous is automatically in the
process operating level. To change to the process operating level from the configuration level, confirm
the menu item END by pressing the MANUAL/AUTOMATIC key.
In the process operating level, normal controlled operation is executed and monitored (in the
AUTOMATIC mode), and the valve opened or closed by hand (MANUAL mode).
Switching between the operating modes
Operate the MANUAL/AUTOMATIC key to switch between the MANUAL and
AUTOMATIC modes.
Both in the MANUAL and the AUTOMATIC modes, you can change to the configuration
level by pressing the MANUAL/AUTOMATIC key for longer than 5 seconds. On switching
back to the process operating level, the operating mode is resumed that was set before
5 sec
switching over.
Operating mode
AUTOMATIC
MANUAL
112 - 8630
Yellow LED in the
MANUAL/AUTOMATIC key
flashes
off
Display
An apostrophe (') runs continuously
from left to right.
-