General Notes; Technical Data; Safety Settings On Bus Failure - Burkert 8630 Operating Instructions Manual

P DP
ROFIBUS

General notes

he following functions are invalid for the TOP Control Continuous with PROFIBUS DP:
• INPUT
• CAL.USER / CAL INP
• CAL.USER / CAL OUT
• CAL.USER / CAL SP

Technical data

The protocol sequence corresponds to DIN 19245 Part 3.
GSD file
Bitmap files
PNO-ID
Baud rate
Sync and freeze mode
Diagnosis telegram
Parameter telegram
Configuration of the process data is performed in the TOP Control and in the PROFIBUS Master.
A maximum of 10 process values (sum of input and output) can be transferred.

Safety settings on bus failure

The actuator moves to the position corresponding to the setpoint last transmitted (default setting).
For other setting options (see the chapter Settings on the TOP Control Continuous )
118 - 8630
BUERC630.GSD
BUEC630.DIB
BUEC630N.BMP (for Siemens COM-PROFIBUS)
BUEC630D.BMP (for Siemens COM-PROFIBUS)
C630 Hex
max. 1.5 Mbaud
(automatically set by TOP Control Continuous)
not supported
no device-specific diagnosis
no user parameters