Electrical Connection - Multipole Connectors; Marking Of The Multipole Plugs Or Sockets And The Contacts - Burkert 8630 Operating Instructions Manual

I
NSTALLATION

* Electrical connection - multipole connectors

ATTENTION!
For connection to the technical earth (ground) (TE), a threaded stud with nut is
provided on the connection module. To assure electromagnetic compatibility (EMC),
connect this stud to a suitable earthing (grounding) point using as short a cable as
possible (max. 30 cm).
Use of the 4 - 20 mA setpoint input
NOTE
If the voltage supply of a TOP Control device fails in a row of such devices connected in
series, the input of the failed device will become high-impedance. This will cause the 4 -
20 mA standard signal to fail. If this occurs, please contact Bürkert Service directly.
With Profibus DP or DeviceNet:
The markings of the multipole plugs and sockets, and the contacts are to be found in the
respective chapters.

Marking of the multipole plugs or sockets and the contacts

M16
M8
Process value
44 - 8630
Output signals to
SPC
TE
Initiators (inductive proximity switches)
M12
M8
Operating voltage