Commissioning And Set-Up As A Positioner; Procedure For Specifying The Basic Settings - Burkert 8630 Operating Instructions Manual

Commissioning and set-up as a positioner

➔ Before commissioning, execute the fluidic and electrical installations.

Procedure for specifying the basic settings

➔ On first commissioning of the TOP Control Continuous, carry out the following basic settings:
• Specify the function of the pneumatic actuator used.
• Specify the standard signal input for setpoint setting (4..20 mA, 0..20 mA, 0..10 V or 0..5 V).
• Start the automatic adaptation of the positioner to the current operating conditions (AUTOTUNE).
Configuration of the keys
MANUAL/AUTOMATIC-key
Arrow keys
Factory setting of the positioner
Function
ACTFUNC
INPUT
CHARACT
DIR.CMD
CUTOFF
DIR.ACT
SPLTRNG
X.LIMIT
X.TIME
T.OPN
T.CLS
After execution of SETFACT: 1 s
Factory setting
FUNCSNGL
INP 4'20A
CHA LIN
DIR.CRISE
CUT = 0 %; CUT = 100 %
DIR.ARISE
SR = 0 (%); SR = 100 (%)
LIM = 0%, LIM = 100%
Values determined by AUTOTUNE
Values determined by AUTOTUNE
O
PERATION AND
Switch between main and sub-menu items, e.g.
ACT FUNC - FUNCSNGL
Switch between eual-ranking menu items, e.g.
ACTFUNC - INPUT
Function
OUTPUT
OUT ANL:
OUT POS
OUT BIN:
OUT DEV
BIN-IN
B.IN SPOS
X.CONTROL
X.CO DBND
X.CO PARA
KX
KX
After execution of SETFACT: 1
CODE
C F
ONTROLLER UNCTIONS
Factory setting
OUT 4 ' 20 A
DEV 5.0 NO
SPOS 000 NO
1 %
Values determined by AUTOTUNE
Values determined by AUTOTUNE
CODE 0000
8630 - 53