Electrical Installation - Multipole Connector - Burkert 8630 Operating Instructions Manual

* Electrical installation - multipole connector

M16
Configuration of the circular connector M 16
Pin Allocation
B Setpoint +
A Setpoint GND
➔ Apply the supply voltage to the circular connector M12
Configuration of the circular connector M 12
Pin Allocation
1 + 24 V
2 not connected
3 GND
4 not connected
NOTE Further installation notes are to be found in the chapter Installation .
After application of the supply voltage, the TOP Control Continuous is in operation. Carry out the
necessary basic settings and initiate self-parametrization of the TOP Control.
M12
External connection/Signal level
(0/4 ... 20 mA
B
or 0 ... 5/10 V)
A
1
3
➔ Apply the setpoint signal to the circular
connector M16
+ (0/4 ... 20 mA or 0 ... 5 / 10 V)
GND
External connection
24 V DC ± 10 %
max. residual ripple 10 %
F C
IRST OMMISSIONING
8630 - 35