Electrical Installation - Connection Terminals For Cable Bushings - Burkert 8630 Operating Instructions Manual

F C
IRST OMMISSIONING

* Electrical installation - connection terminals for cable bushings

➔ Remove the cover with the cable bushings
to gain access to the terminals. This is done
by unscrewing the 4 self-tapping screws.
➔ Apply the setpoint signal and the supply
voltage to the respective terminals (see
Terminal configuration with cable bushings ).
Terminal configuration with cable bushings
Terminal Allocation
1 Setpoint +
2 Setpoint GND
5 Operating voltage +
6 Operating voltage GND
NOTE Further installation notes are to be found in the chapter Installation .
After application of the supply voltage, the TOP Control Continuous is in operation. Carry out the
necessary basic settings and initiate self-parametrization of the TOP Control.
36 - 8630
screw terminals
External connection
1
+ + (0/4 ... 20 mA or 0 ... 5/10 V)
2
GND
5
24 V DC ± 10 %
max. residual ripple 10 %
6