Pre-Bound Ad Splice - Imagine communications Selenio BNP 2xr User Manual

ETV Binary Interchange Format
Note: In all of the following Use Cases (except as specified as "Non-DPI") it is assumed that the BNP is
configured for DPI. See
DPI.

Pre-Bound Ad Splice

In pre-bound ad splicing, the input network (or program) stream does not contain ETV data; rather, an
ad containing ETV data ESs is spliced in later. In this case, the BNP would be configured to play the ad's
ETV streams on the output during the ad splice.
Figure 170 shows an example of pre-bound ad splice.
Figure 170. Pre-bound Ad Splice flow
Pid Type
Video
Audio
Sat. Receiver
Sat. Receiver
Configuration Steps:
To configure pre-bound ad splice:
1. From the BNP Element Manager, click on the Grooming -> Mapping tab.
2. Create an output transport stream, if necessary. (See the section that begins with, "Managing
Output Transport Streams" on page 113 for additional information.)
3. Use the Drag and Drop Grooming
transport stream (oTS), as seen in
Note: In this use case, the input program does not contain any ETV elementary streams.
Selenio TM BNP User Guide, Release 3.7.1
- Use Case Configuration Examples
Chapter 8, "Digital Program Insertion (DPI)"
Pid Type
Video
Audio
EBIF EISS
EBIF Data
DPI Pump
Advertisement
Broadcast
Local EBIF
Local EBIF
Streamer
feature to groom a desired input program to the desired output
Figure 171, for example.
DPI Pump
Output MUX
BNP
BNP
Streamer
for details on configuring
Spliced Program
Pid Type
Video
Audio
EBIF EISS
EBIF Data
STB
STB
Broadcast Program
Pid Type
Video
Audio
EBIF EISS
EBIF Data
238