Creating Programs - Imagine communications Selenio BNP 2xr User Manual

Grooming and PSIP
- Grooming - Mapping
Table 67. Create Output Transport Stream (FAT ASI) (Continued)
Field
TS Type
Enable Messaging System
Number of Group
Group Name (A-D)
Group Bitrate (Mbps)
(A-D)
H.264 Alarm Bitrate Level
(Mbps)
Reserved B/W (Mbps)
Figure 77. FAT ASI Ports Created

Creating Programs

Use information in this section to create output programs, as described in the following topics:
"Creating Programs Manually," next.
•
"Program Messaging System Setting" on page 134.
•
Note: With the exception of ghost programs, input programs cannot be created; these must be
automatically detected from a GigE or ASI port. For information about ghost program creation,
see "Managing Elementary Streams" on page 156.
You can create output programs in one of two ways:
Selenio TM BNP User Guide, Release 3.7.1
Description
The type of stream. The type of stream you choose determines what other
information is required. Choices are:
MPEG-2, ATSC, SCTE, or DVB
• For information on additional fields for ATSC transport streams, see
Table 65.
• For information on additional fields for DVB transport streams, see
Table 66.
Check this box to allow configuration of Messaging System zones for specific
programs in this transport stream. See "Messaging System Configuration" on
page 60 for information on configuring Messaging Zones.
The number of groups you want to assign to this port. Choose from 1 to 4.
The default is 4.
The name you want to assign to each group.
The bitrate, in megabits per second, that you want to assign to groups. The
value entered will be applied to all Groups. The total bitrate for all groups
cannot exceed the value in the Bitrate field in the top portion of the window.
Assists in maintaining video quality for MPEG-2 video content in the
presence of H.264 content, which bypasses the BNP's transrater. This is
done by generating an alarm when H.264 program bandwidth exceeds the
percent of the TS bandwidth specified in this setting.
Choices are: 0%, 25%, 50%, 75%, 100%.
The reserved bandwidth you want to assign for each group. The total
bandwidth for all groups cannot exceed the value in the Reserved B/W field
in the top portion of the window.
130