Configuring Dvb-Ca: External And Internal Eis Mode - Imagine communications Selenio BNP 2xr User Manual

DVB Conditional Access
Table 94. DVB-CA Global Configuration fields (Continued)
Field
EMM Multicast IP
Update Timer (secs)

Configuring DVB-CA: External and Internal EIS Mode

Use steps in this section to configure DVB-CA for external and internal EIS modes. For internal EIS
mode, please include the additional steps provided in "Configuring DVB-CA for Internal EIS Mode" on
page 230 to complete that configuration.
The tasks for this configuration are provided in the following topics:
"Step 1, Create CA System" on page
•
"Step 2, Create ECMG" on page
•
"Step 3, Create EMMG" on page
•
"Step 4, Create EMM" on page
•
"Step 5, Join TS to EMM" on page
•
"Step 6, Verify Scrambling" on page
•
Selenio TM BNP User Guide, Release 3.7.1
- DVB-CA Configuration
Description
Specifies the multicast IP address on which
Ethernet Port 2 will receive EMM packets.
• Enter a valid multicast IP address in this field to
enable Ethernet Port 2 for receiving EMM
packets.
• Enter all 0's (or leave field at the default of all
0's) to not send EMM traffic via Ethernet Port 2.
Specifies the amount of time (in seconds) before
the BNP should begin to transmit video services
in order to allow for encryption processing.
• Default is 0.
• The higher the number, the longer it will take
the end user to receive a video signal. If the
number is too low, programming will be
transmitted in the clear until the encryption
engine takes over. The recommendation is to
choose a number that will be an acceptable
level of delay for the end user while still
providing the minimum amount of clear data
transmission.
223.
225.
225.
226.
223.
228.
Internal EIS mode or
External EIS mode
Common to both
Common to both
222