Setting Up An Ntp Server; Configuring Ethernet Control Port For Dvb-Ca - Imagine communications Selenio BNP 2xr User Manual

DVB Conditional Access

Setting Up an NTP Server

To enable proper interaction of the DVB-CA feature with the CAS, a network time protocol (NTP) server
must be set up in the Element Manager such that the IP Address of the NTP server is from the same
source as that used by the CAS.
Use the Global configuration tab page to set NTP parameters.
Access via BNP Element Manager Configuration
Menu Path
tab -> Global tab screen.
1. At the Server 1: field, type the IP address of the NTP server,
in dotted decimal format.
2. Click the Apply Configuration button to save and use the
settings displayed in this tab page.

Configuring Ethernet Control Port for DVB-CA

Of the two 10/100 Base T Ethernet management ports on the BNP, only Ethernet Port 2 is available for
management access to the CAS. However, you must configure an IP address for both Ethernet Port 1
and Ethernet Port 2 for proper DVB-CA functionality.
The ports you will configure at the Element Manager are mapped to the physical ports of the BNP as
shown in Figure
Figure 148. DVB-CA - Ethernet Control Port mapping
Use the Ethernet Control Port tab page to configure the BNP control ports.
Access via BNP Element Manager Configuration tab -> Ethernet Control Port tab
Menu Path
screen.
1. In the Ethernet Port 2 section, type the IP Address, Subnet Mask, Gateway, and DNS Server
(optional) to which the CAS will connect.
Selenio TM BNP User Guide, Release 3.7.1
- DVB-CA Configuration
148.
10/100-1 -->
Ethernet Port 2
10/100-0 -->
Ethernet Port 1
210