SMA SUNNY CENTRAL 500CP XT User Manual page 116

11 Operating Data and Parameters
Errors and warnings relating to the reactive power setpoint
Name
Q-VArModFailStt
Status messages of the reactive power setpoint
Name
Q-VArModStt
Displacement power factor and power setpoint
Name
PF
PFExt
P-WSpt
116 SCCPXT-E7-BA-en-58
Display Description
Off No mode for specifying the reactive power setpoint has been se-
lected.
Ok A mode for specifying the reactive power setpoint has been selected
and no error is present.
ComFail The mode VArCtlCom or PFCtlCom has been selected and the ex-
pected signal with a valid reactive power setpoint has been absent
for at least five minutes.
AnInFail
The mode VArCnstNomAnIn or PFCnstAnIn has been selected
and the value measured at the analog input is less than 2 mA.
ComInvalid The mode VArCtlCom or PFCtlCom has been selected and there is
invalid content in the power setpoint information.
Display Description
Off No mode for specifying the reactive power setpoint has been se-
lected.
VdcMax The reactive power is limited due to DC voltage being too high.
VacLimMax The reactive power is limited due to AC voltage being too high.
VacLimMin The reactive power is limited due to the AC voltage being too low.
SMaxVdcHigh The maximum apparent power value is reduced. If the maximum DC
voltage increases, the reactive power is reduced.
SMax The reactive power is limited by the maximum apparent power.
Tmp The reactive power is limited by temperature derating.
AmpAC The reactive power is limited via an AC current limitation.
P The reactive power is limited due to the priority of the active power
setpoint.
FrtLim The reactive power is limited due to the FRT voltage limit.
Display Description
− Current displacement power factor cos φ
OvExt Overexcited
UnExt Underexcited
− Current power specification
SMA Solar Technology AG
User Manual