Reset Meter To Factory Defaults - FlowLine DataView LI55 Instruction Manual

Level controller

Hide thumbs Also See for DataView LI55:

Table of Contents

DataView™ LI55 Level Controller

Reset Meter to Factory Defaults

When the parameters have been changed in a way that is difficult to determine

what's happening, it might be better to start the setup process from the factory

defaults.

Instructions to load factory defaults:

Press and hold MENU for 5 seconds to access the Full Menu

From Setup, press and hold MENU for 3 seconds to access the Advanced

Features Menu

Press Up button to go to Diagnostics menu

Press and hold Right button for three seconds, press

Enter when display flashes rEsEt.

Note: If Enter is not pressed within three seconds, the display returns to the

Diagnostics menu.

The meter goes through an initialization sequence (similar as on power-up),

and loads the factory default settings.

Note: The dual-scale selection for some level applications (d-SCAL) is not reset

to the single scale factory default. This can be changed using the Setup –

Input menu.

MN301033 Rev B1

RIGHT

Instruction Manual

ENTER

to accept

Table of Contents

Do you have a question about the DataView LI55 and is the answer not in the manual?