Table of Contents
Advertisement
DataView™ LI55 Level Controller
SETUP AND PROGRAMMING
The meter is factory calibrated prior to shipment to read in
milliamps and volts depending on the input selection. The
calibration equipment is certified to NIST standards.
Overview
There are no jumpers to set for the meter input selection.
Setup and programming is done through the front panel buttons.
After power and input signal connections have been completed and verified,
apply power to the meter.
MN301033 Rev B1
Instruction Manual
27
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the DataView LI55 and is the answer not in the manual?