Making Changes To A Password Protected Meter; Disabling Password Protection - FlowLine DataView LI55 Instruction Manual

DataView™ LI55 Level Controller

Making Changes to a Password Protected Meter

If the meter is password protected, the meter will display the message Locd
(Locked) when the Menu button is pressed. Press the Enter button while the
message is being displayed and enter the correct password to gain access to the
menu. After exiting the programming mode, the meter returns to its password
protected condition.

Disabling Password Protection

To disable the password protection, access the Password menu and enter the
correct password twice, as shown below. The meter is now unprotected until a
new password is entered.
MENU
ENTER
If the correct six-digit password is entered, the meter displays the message
unLoc (unlocked) and the protection is disabled until a new password is
programmed.
If the password entered is incorrect, the meter displays the message Locd
(Locked) for about two seconds, and then it returns to Run Mode. To try again,
press Enter while the Locked message is displayed.
Did you forget the password?
The password may be disabled by entering a master
password once. If you are authorized to make changes,
enter the master password 508655 to unlock the meter.
74
UP
UP
ENTER
Instruction Manual
ENTER
ENTER
MN301033 Rev B1