Chrysler 1997 Stratus Convertible RHD Service Manual page 1118

QUARTER WINDOW MOD LATCH PLATE HOOK NUT INNER QUARTER PANEL INNER QUARTER PANEL QUARTER GLASS ULE
QUARTER QUARTER GLASS GLASS CHANNEL LIFT
23 - 48 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 64 Quarter Glass
(6) Install quarter trim panel.
QUARTER WINDOW MODULE
REMOVAL
(1) Raise quarter glass to full up position, if possi-
ble, to aid in removal.
(2) Remove quarter trim panel.
(3) Partially lower convertible top.
(4) Disconnect wire connector to power window
motor.
(5) Remove fasteners holding quarter window mod-
ule to inner quarter panel (Fig. 65).
(6) Lift quarter window module upward and out
opening at top of quarter panel.
(7) Separate quarter glass from quarter window
module (Fig. 66).
Fig. 65 Quarter Window Module
INSTALLATION
(1) Lower quarter window module into position
through opening in top of quarter panel.
POWER QUARTER WINDOW QUARTER GLASS MOTOR
QUARTER WINDOW MOD- ULE
Fig. 66 Quarter Glass
(2) Install fasteners holding quarter window mod-
ule to inner quarter panel.
(3) Connect wire connector to power window motor.
(4) Raise glass lift channel to full up position.
(5) Position quarter glass on quarter window mod-
ule.
(6) Loosely install fasteners holding quarter glass
to quarter window module.
(7) Lower and secure convertible top.
(8) Adjust quarter glass as necessary. Refer to
quarter glass adjustment procedure in this section.
(9) Install quarter trim panel.
CARPET
REMOVAL
(1) Lower convertible top to full down position.
(2) Remove front seats.
(3) Remove rear seat cushion.
(4) Remove floor console and forward instrument
panel console.
(5) Remove door sill trim panels.
(6) Remove cowl trim panels.
(7) Remove quarter trim panels.
(8) Remove amplifier on passenger side of floor
pan, if so equipped.
(9) Remove wiring troughs holding carpet at out-
board ends of rear seat crossmember.
(10) Remove push–in fasteners from rear of carpet
holding carpet to rear seat crossmember (Fig. 67).
(11) Remove plastic sill retainers from metal clips
along door sill panel.
(12) Separate carpet from vehicle (Fig. 67).
INSTALLATION
(1) Position carpet in vehicle.
(2) Install push–in fasteners from rear of carpet
holding carpet to rear seat crossmember.
JX