Chrysler 1997 Stratus Convertible RHD Service Manual page 1024

HOOK T OOL #2 (NOTE BEARING SMALL TABS) NEEDLE 3
21 - 56 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 228 Check Reverse Clutch Pack Clearance
The reverse clutch pack clearance is 0.76 to
1.24 mm (.030 to .049 inch). Select the proper
reverse clutch snap ring to achieve specifications:
REVERSE CLUTCH SNAP RING CHART
All clutch clearances in the input clutch retainer
have now been checked and approved.
To complete the assembly of the input clutch
retainer, the reverse clutch and the overdrive clutch
must be removed from the retainer.
CAUTION: Do not intermix clutch parts. Keep in
exact same order.
Now proceed with the next phase of the assembly:
Fig. 229 Install No. 2 Needle Bearing
WITH COMPRESS CLUTCH PACK FINGER INDICATOR TO ZERO TABS UP OVERDRIVE SHAFT ASSEMBLY WASHER (NOTE 5 #3 UNDERDRIVE #2 #3 THRUST PLATE (NOTE 3 BEARING NEEDLE THRUST ASSEMBLY TABS) SHAFT TABS)
Fig. 230 Install Underdrive Shaft Assembly
Fig. 231 Install No. 3 Thrust Washer
Fig. 232 Install No. 3 Thrust Plate
DABS UNDERDRIVE OF (FOR RETENTION) PETROLATUM ASSEMBLY SHAFT
JX