Chrysler 1997 Stratus Convertible RHD Service Manual page 1000

#4 #1 CAGED NEEDLE #4 THRUST WASHER WASHER THRUST BEARING
21 - 32 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
CAUTION: The cooler bypass valve must be replaced if
a transaxle failure has occurred. Do not reuse old valve
or attempt to clean old valve. When installing bypass
valve, insert with O-ring end towards rear of case.
Fig. 92 Caged Needle Bearing
Fig. 93 Input Clutches Assembly
Fig. 94 Front Sun Gear Assembly
FRONT CLUTCHES INPUT SUN ASSEMBLY ASSEMBLY GEAR #6 NEEDLE BEAR-
NOTE: TANGED
SIDE OUT
REAR #7 TO REMOVE OR INSTALL COMPRESS JUST ENOUGH
Fig. 95 Front Carrier and Rear Annulus Assembly
ING
GEAR SNAP RING BEARING SUN NEEDLE SNAP RING
Fig. 96 Rear Sun Gear
Fig. 97 2/4 Clutch Retainer Snap Ring
(TWIST AND PULL OR PUSH ANNULUS FRONT CARRIER AND REAR TO REMOVE OR INSTALL). ASSEMBLY
JX
TOOL 5058 SCREW- DRIVER 24 RETAINER CLUTCH