Chrysler 1997 Stratus Convertible RHD Service Manual page 1085

JX
REMOVAL AND INSTALLATION (Continued)
(4) Pull seat cover from seat back frame and seat
back foam.
(5) Remove any hog rings holding seat cover seam
wires to seat foam wires.
(6) Separate seat cover from seat frame and seat
back foam.
INSTALLATION
(1) Position seat cover to seat back frame and seat
back foam.
(2) Align notch in center of seat back cover vertical
seam to center hog ring locator.
(3) Install a hog ring at each hog ring location,
center first, to hold seat back cover seam to wires in
seat back foam.
(4) Repeat the above steps for the opposite inboard
vertical seam, both outboard vertical seams, and the
lower horizontal seam.
(5) If vehicle is equipped with cloth seats;
(a) Install hog rings at each hog ring locator,
center first, to attach ends of vertical portions of
U-shaped wires to vertical foam wires.
(b) Align notch in center of upper horizontal seat
cover seam to center hog ring location.
(c) Install a hog ring at each hog ring locator to
hold upper horizontal seam wire to wire in seat
back foam.
(6) Install hog rings holding seat cover seam wires
to seat frame.
(7) Pull seat cover over seat back frame and seat
back foam.
(8) Install hog rings at hog ring locators around
perimeter of seat back cushion holding seat cover to
seat back frame.
(9) Install rear seat back to vehicle. Refer to pro-
cedures found in this section.
BODY 23 - 15