Chrysler 1997 Stratus Convertible RHD Service Manual page 1110

HEADER PANEL SUN VISOR
INSIDE REAR VIEW MIRROR HEADER PANEL
23 - 40 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 46 Sun Visor
INSIDE REAR VIEW MIRROR
REMOVAL
(1) Remove screws holding inside rear view mirror
to header panel.
(2) Disconnect wire connector to rear view mirror,
if so equipped.
(3) Separate rear view mirror from vehicle (Fig.
47)
Fig. 47 Inside Rear View Mirror
INSTALLATION
(1) Position inside rear view mirror to vehicle.
(2) Connect wire connector to rear view mirror, if
so equipped.
(3) Install screws holding rear view mirror to
header panel.
A–PILLAR TRIM PANEL
REMOVAL
(1) Disengage clips holding A–pillar trim panel to
A–pillar.
A PILLAR TRIM PANEL HEADER TRIM PANEL
A-PILLAR HEADER
(2) Separate trim panel from vehicle (Fig. 48).
Fig. 48 A–Pillar Trim Panel
INSTALLATION
(1) Position trim panel near A–pillar.
(2) Align locating pins on back side of trim panel
to holes in A–pillar.
(3) Press clips on A–pillar trim panel into slots in
A–pillar.
HEADER TRIM PANEL—RIGHT OR LEFT
REMOVAL
(1) Remove sun visor.
(2) Remove inside rear view mirror, right side only.
(3) Disengage clip holding header trim panel to
header panel.
(4) Separate header trim panel from vehicle (Fig.
49).
Fig. 49 Header Trim Panel
INSTALLATION
(1) Position header trim panel on vehicle.
(2) Align locating pins on back side of trim panel
to holes in header panel.
JX