Chrysler 1997 Stratus Convertible RHD Service Manual page 1089

HYDRAULIC PUMP ASSEM- MOUNTING BRACKET HYDRAULIC LINES RUBBER MALLET LOCKING STRIP BLY
JX
REMOVAL AND INSTALLATION (Continued)
CAUTION: Make sure top well is not trapped under
the tack strips.
(18) Latch top and inspect for wrinkles.
Fig. 4 Backlite Locking Strip
HYDRAULIC PUMP ASSEMBLY
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove rear seat cushion and rear seat back.
(3) Disconnect pump wire connector and ground
connection (Fig. 5).
(4) Disconnect hydraulic lines from pump.
(5) Remove motor pump assembly from vehicle.
The rubber mounts are pressed and locked into the
mounting bracket. Pull up on motor assembly to
remove.
Fig. 5 Hydraulic Pump Assembly
CONVERTIBLE TOP LOWER HYDRAULIC CYLINDER PIVOT
INSTALLATION
(1) Position hydraulic motor in vehicle.
(2) Press hydraulic motor into mounts.
(3) Connect hydraulic lines to pump.
(4) Connect pump wire connector and ground con-
nection.
(5) Connect battery negative cable.
(6) Fill and verify operation of hydraulic pump.
(7) Install rear seat cushion and rear seat back.
HYDRAULIC CYLINDER
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove rear seat cushion and rear seat back.
(3) Remove quarter trim panel.
(4) Remove cylinder mounting bracket and nut
(Fig. 6).
(5) Remove pivot bolt holding cylinder shaft to top
linkage.
(6) Disconnect hydraulic lines from the cylinder.
(7) Remove cylinder from vehicle.
Fig. 6 Hydraulic Cylinder
INSTALLATION
Reverse the preceding operation. Fill hydraulic sys-
tem and check for proper operation.
HYDRAULIC LINES
REMOVAL
(1) Remove rear seat cushion and rear seat back.
(2) Remove both quarter trim panels.
(3) Disconnect hydraulic line from hydraulic cylin-
ders.
(4) Disconnect hydraulic line from hydraulic pump.
(5) Separate hydraulic line from vehicle.
BODY 23 - 19