Discharge Line - Chrysler 1997 Stratus Convertible RHD Service Manual

24 - 18 HEATING AND AIR CONDITIONING
CONTROL SCREWS MODULE
REMOVAL AND INSTALLATION (Continued)
(3) Remove cluster hood bezel retaining screws in
the trim bezel opening (Fig. 30).
Fig. 30 Control Module Screws
(4) Pry up the cluster hood bezel a few inches to
expose the cubby bin/cigar lighter bezel screws.
(5) Remove the cubby bin/cigar lighter bezel and
wiring.
(6) Remove the control module retaining screws.
(7) Drop the A/C control module into the cigar
lighter/cubby bin bezel opening (Fig. 31). Then dis-
connect the wiring on the rear of the control module.
Fig. 31 Control Module At Bezel Opening
(8) Release the cable clips from the top of the con-
trol module. Retain the clips for future use. Then dis-
connect the temperature control and recirculation
control cables.
(9) Remove the control module.
INSTALLATION
For installation, reverse the above procedures. Ver-
ify that the cables are properly adjusted and the
module is seated properly.
CLUSTER
CONTROL MODULE
SCREWS HOOD
CABLE ADJUSTMENT
The cables must be adjusted for proper function of
the control module. To adjust the cable, attach the
cable to the lever arm of the control module. Turn
SPECIAL TOOL OTC 7241
the knob fully counterclockwise. Pull the cable jacket
away from the cable end until taut. Clip the cable
jacket to the control module. The knob should travel
a full 180° if the cable is properly adjusted.

DISCHARGE LINE

REMOVAL
(1) Remove refrigerant from the A/C system using
a refrigerant recovery machine.
(2) Disconnect A/C pressure transducer wire har-
ness.
(3) Remove quick connect clip and disconnect quick
connect at condenser using Special Tool kit 7193 (Fig.
32) and (Fig. 33).
Fig. 33 Special Tool For Line At Condenser
CAUTION: Cap all lines that are not being replaced
and cap the expansion valve tubes.
DISCHARGE LINE CLIP
Fig. 32 Quick Connect Clip
JX
DISCHARGELINE