Chrysler 1997 Stratus Convertible RHD Service Manual page 1100

WINDOW REGULATOR INNER DOOR PANEL REAR GUIDE BOLTS LIFT CHANNEL FRONT DOOR FRONT DOOR NUT NUT
23 - 30 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 13 Inner Belt Stabilizer
Fig. 14 Regulator Lift Channel
Fig. 15 Rear Guide Bolts
WINDOW REGULATOR
NOTE: For power window motor service proce-
dures, refer to Group 8S, Power Windows.
INNER BELT STABILIZER
REMOVAL
(1) Remove door trim panel and water shield.
(2) Disconnect wire connector to power window
motor.
(3) Remove nuts holding regulator lift channel to
door glass (Fig. 17).
(4) Secure door glass in upward position.
(5) Mark position of rear bolt of roller channel to
inner door panel to aid in installation.
(6) Remove bolt holding rear of roller channel to
door panel.
(7) Loosen bolt holding front of roller channel to
door panel.
(8) Separate roller channel from door panel (Fig.
18).
(9) Loosen bolts holding window regulator to inner
door panel reinforcement.
(10) Separate bolt heads from key-hole slots in
inner door panel.
(11) Remove window regulator through large hole
in inner door panel (Fig. 19).
(12) Remove power window motor from regulator.
Refer to Group 8S, Power Windows, for motor proce-
dure.
INSTALLATION
(1) Install power window motor on regulator. Refer
to group 8S, Power Windows, for motor procedures.
(2) Move window regulator into position in door
and engage bolt heads into key-hole slots in inner
door panel reinforcement and tighten bolts.
(3) Install roller channel to door panel.
DOOR DOOR GLASS
Fig. 16 Door Glass—Typical
JX