Chrysler 1997 Stratus Convertible RHD Service Manual page 1115

FORWARD PANEL CONSOLE GEAR SHIFTER INSTRUMENT PARK BRAKE
INSTRUMENT PANEL
JX
REMOVAL AND INSTALLATION (Continued)
Fig. 56 Forward Instrument Panel Console
(8) Install left knee bolster. Refer to Group 8E,
Instrument Panel and Gauges, for proper procedure.
(9) Install instrument panel center bezel. Refer to
Group 8E, Instrument Panel and Gauges, for proper
procedure.
(10) Install instrument panel cluster hood. Refer to
Group 8E, Instrument Panel and Gauges, for proper
procedure.
(11) Install floor console.
REAR SEAT CUSHION
NOTE: Special care should be taken when remov-
ing rear seat cushion to prevent damage to the
cushion frame. Remove cushion at attachment
areas, not at wing area.
REMOVAL
(1) Push firmly rearward and upward at one
attachment point and disengage wire loops from
retainers in floor pan (Fig. 57).
(2) Repeat for other attachment point.
(3) Separate rear seat cushion from vehicle.
INSTALLATION
(1) Position rear seat cushion in vehicle.
(2) Place inner seat belts on top of seat cushion.
INNER SEAT BELT ASSEM REAR SEAT CUSHION INNER SEAT BELTS FLOOR PAN BLY
REAR SEAT BACK REAR SEAT BACK
Fig. 57 Rear Seat Cushion
(3) Push seat cushion rearward and align wire
loops to retainers in floor pan.
(4) Push rear seat cushion firmly downward and
engage wire loops to retainers in floor pan.
REAR SEAT BACK
REMOVAL
(1) Remove rear seat cushion.
(2) Remove rear inner seat belt assembly (Fig. 58).
(3) Pull bottom of rear seat back forward until seat
back brackets clear studs on floor pan (Fig. 59).
(4) Push upward on rear seat back and disengage
hooks holding seat back to rear seat back support.
(5) Separate rear seat back from vehicle.
Fig. 58 Rear Inner Seat Belt Assembly
INSTALLATION
(1) Position rear seat back in vehicle.
(2) Tilt rear seat back rearward and raise seat
back above retaining brackets on rear seat back sup-
port.
BODY 23 - 45