Recirculation Door Cable - Chrysler 1997 Stratus Convertible RHD Service Manual

DISCHARGELINE SPECIAL TOOL OTC 7240 LIQUID LINE CLIP
24 - 26 HEATING AND AIR CONDITIONING
REMOVAL AND INSTALLATION (Continued)
Fig. 61 Clip Removal
Fig. 62 Quick Coupler Using Special Tool 7240
Fig. 63 Line At Condenser
DOUBLE O-RINGS LIQUID LINE
LIQUID LINE
TEMPERATURE CONTROL MODULE DOOR CABLE
LIQUID LINE AT RECEIVER- DRIER
Fig. 64 Liquid Line at Receiver/Drier

RECIRCULATION DOOR CABLE

The RECIRC door is actuated by a cable which
mechanically positions the door.
The RECIRC door actuator is located at the far
right of the A/C Heater housing near the right A-pil-
lar (Fig. 65).
Fig. 65 Recirculation Cable Location
REMOVAL
(1) Place the ignition key in the OFF position
before removing control module.
(2) Remove trim bezel (Fig. 66).
(3) Remove cluster hood bezel retaining screws in
the trim bezel opening (Fig. 67).
(4) Pry up the cluster hood bezel a few inches to
expose the cubby bin/cigar lighter bezel screws.
(5) Remove the cubby bin/cigar lighter bezel and
wiring.
(6) Remove the control module retaining screws.
(7) Drop the A/C control module into the cigar
lighter/cubby bin bezel opening (Fig. 68). Then dis-
connect the wiring on the rear of the control module.
(8) Release the recirculation cable retaining clip from
the top of the control module. Retain the clip for future
use. Then disconnect the recirculation control cable.
RECIRCULATION DOOR A/C HOUSING CABLE
JX