Chrysler 1997 Stratus Convertible RHD Service Manual page 1102

REAR VERTICAL GUIDE BAR JACK SCREW DOOR
23 - 32 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 21 Rear Vertical Guide Bar
(4) Install nut holding top of rear guide bar to
inner door panel.
(5) Verify glass fit and operation. Adjust door glass
as necessary.
(6) Install door trim panel and watershield.
DOOR TRIM PANEL
REMOVAL
(1) Roll door glass down.
(2) Disengage clips holding speaker grille to door
trim panel.
(3) Remove screws holding door trim panel to door
(Fig. 22).
(4) Disengage clips holding perimeter of trim panel
to door (Fig. 23).
(5) Lift trim panel upward and disengage trim
panel from upper retainer channel.
(6) Tilt trim panel away from door.
(7) Disengage clip holding latch linkage to back of
inside door handle.
(8) Disconnect electrical connectors as necessary.
(9) Separate door trim panel from door.
INSTALLATION
(1) Position door trim panel next to door.
(2) Connect electrical connectors as necessary.
(3) Engage clip holding latch linkage to inside door
handle.
(4) Position door trim panel on door and engage
trim panel to upper retainer channel.
(5) Engage clips holding perimeter of trim panel to
door.
(6) Install screws holding trim panel to door.
(7) Engage clips holding speaker grille to door trim
panel.
INSIDE LATCH HANDLE DOOR TRIM PANEL DOOR TRIM PANEL FRONT DOOR PULL CUP DOOR CLIPS CAP
Fig. 22 Door Trim Panel Screws
Fig. 23 Door Trim Panel Clips
DOOR WATERSHIELD
REMOVAL
(1) Remove door trim panel.
(2) Remove door speaker, if equipped.
(3) Remove door trim pull cup mount bracket.
(4) Disengage clip holding lock linkage to lock but-
ton bell crank.
(5) Peel watershield away from adhesive around
perimeter of inner door panel (Fig. 24).
INSTALLATION
(1) Insure that enough
securely retain the watershield. Replace as necessary.
(2) Place the watershield into position and press
securely to adhesive making sure to properly route
wiring and linkages.
(3) Engage clip holding lock linkage to lock button
bell-crank.
(4) Install door trim pull cup mount bracket.
(5) Install door speaker, if equipped.
(6) Install door trim panel.
JX
adhesive remains to