Chrysler 1997 Stratus Convertible RHD Service Manual page 1141

JX
REMOVAL AND INSTALLATION (Continued)
NOTE: A slight release of pressure trapped in the
fitting may be experienced. It is not necessary to
discharge the refrigerant system.
(3) Remove the transducer with a counterclockwise
rotation using a 14 mm open-end wrench (Fig. 11)
and (Fig. 12).
Fig. 11 Pressure Transducer (2.4L engine, viewed
from beneath vehicle)
Fig. 12 Pressure Transducer (2.5L engine)
INSTALLATION
For installation, reverse above procedures. Tighten
pressure transducer to 6 N·m (50 in. lbs.).
BLOWER MOTOR AND WHEEL ASSEMBLY
The blower motor is located on the right side of the
heater housing.
REMOVAL
(1) Disconnect battery.
(2) Remove lower right under panel silencer duct.
(3) Remove blower motor connector from resistor
block (Fig. 13).
(4) Remove blower motor case retaining screws.
HEATING AND AIR CONDITIONING
(5) Lower blower motor case from housing (Fig.
14).
(6) Remove fan scroll from motor shaft.
(7) Remove motor from motor case.
INSTALLATION
For installation, reverse the above procedures.
Fig. 13 Blower Motor Wiring
Fig. 14 Blower Motor
BLOWER MOTOR RESISTOR
The blower motor resistor is located on the lower
right side of the heater housing.
REMOVAL
(1) Remove lower right underpanel silencer/duct.
(2) Disconnect wiring connectors on blower motor
resistor.
(3) Remove blower motor resistor retaining screws.
(4) Pull blower motor resistor out of heater hous-
ing (Fig. 15).
INSTALLATION
For installation, reverse the above procedures.
24 - 13