Past Position Display Attributes; Past Position Display Mode - Furuno FAR-2807 Operator's Manual

3.11.2

Past position display attributes

You may select the number of past points to display per plotting interval as
follows.
1. Left-click the MENU box to open the menu.
2. Select 4 [TT•AIS].
3. Select 5 [TT•AIS SYMBOL].
4. Select 4 TT PAST POSN POINTS.
5. Select 5 or 10 as appropriate.
6. Push the right button three times to close the menu.
3.11.3

Past position display mode

The display mode for the past position display is the same as that set for the
target trails. In true motion mode, the true vector is displayed.
[TT•AIS]
1 BACK
2 AZ ZONE STAB
STAB HDG/STAB NORTH
3 AZ POLYGON
OFF/STAB GND/
STAB HDG/STAB NORTH
4 [TRIAL MANEUVER]
5 [TT•AIS SYMBOL]
6 [CPA AUTO ACTIVATE]
7 [AIS DISP FILTER]
8 [AIS LOST FILTER
9 [TT LOST FILTER]
0 [ASSOCIATION]
[TT•AIS SYMBOL]
1 BACK
2 TT•AIS SYMBOL COLOR
RED*/GRN/BLU/YEL*/
CYA/MAG/WHT
3 AIS ROT TAG LIMIT
0.000°/MIN
4 TT PAST POSN POINTS
5/10
5 AIS PAST POSN POINTS
5/10
6 AIS SCALED SYMBOL
OFF/ON
7 AIS BASE STATION
OFF/ON
8 AIS PHYSICAL ATON
OFF/ON
9 AIS VIRTUAL ATON
OFF/ON
TT•AIS SYMBOL menu
3. TARGET TRACKING (TT)
* Not available on
IMO radar
3-19