Install The Replacement Mpmrx Card; Install A New Mpmrx Card In A Powered On Rmx 2000 - Polycom RMX 2000 Hardware Manual

RealPresence Collaboration Server (RMX) 2000 Components and Components Replacement

Install the Replacement MPMRx Card

If only one media card is installed in the system, it must be inserted in the top slot of the RMX chassis.
To install a replacement MPMRx Card:
1 On the card to be installed, move the ejector levers to their fully open position.
2 Slide in the replacement MPMRx card.
3 Push the MPMRx card firmly into the Backplane, making sure it is properly seated in its slot.
4 Ensure that the metal ejector levers are fully retracted into their housings.
5 Tighten the captive screws on the front panel of the RMX that secure the MPMRx card to the
chassis.

Install a New MPMRx Card in a Powered on RMX 2000

If only one media card is installed in the system, it must be inserted in the top slot of the RMX chassis.
To install a new MPMRx card in a powered on RMX 2000:
1 If applicable, loosen the captive screws and remove the slot cover.
2 On the card to be installed, move the ejector levers to their full open position.
3 Insert the card into the slot until the ejector levers touch the front edge of the card cage.
4 Push the ejector levers to their closed position and tighten the captive screws on each side of the
card, securing the MPMRx card to the RMX 2000.
The blue HS LEDs on the MPMRx card and the Control Unit start flashing and the power on cycle for
the card is initiated:
 The card's resources are added to the system resources list.
 The number of available resources on the RMX is usually increased to the current CFS license
level.
 Port usage is re-calculated and the Port Gauges and the Video Port Configuration are updated.
When the power on cycle of the MPMRx card is completed, the blue HS LEDs will turn OFF. The
green RDY LED on the MPMRx card switches on and remains lit.
Polycom, Inc. 55