Table of Contents
Advertisement
RealPresence Collaboration Server (RMX) 2000 Hardware Guide
Installing the Replacement MPM/MPM+/MPMx Card
If only one media card is installed in the system, it must be inserted in the top slot of the
RMX chassis.
1
2
3
4
5
Installing a New MPM/MPM+/MPMx Card in a Powered On RealPresence
Collaboration Server (RMX) 2000
If only one media card is installed in the system, it must be inserted in the top slot of the
RMX chassis.
1
2
3
4
Replacing the RTM IP Card
The RTM IP card on the rear of the RMX 2000 provides connectivity to all the MCU
modules. Use the following procedure to replace the RTM IP card:
1
2
1-34
On the card to be installed, move the ejector levers to their fully open position.
Slide in the replacement MPM/MPM+/MPMx card.
Push the MPM/MPM+/MPMx card firmly into the Backplane, making sure it is
properly seated in its slot.
Ensure that the metal ejector levers are fully retracted into their housings.
Tighten the captive screws on the front panel of the RMX that secure the MPM/
MPM+/MPMx card to the chassis.
If applicable, loosen the captive screws and remove the slot cover.
On the card to be installed, move the ejector levers to their full open position.
Insert the card into the slot until the ejector levers touch the front edge of the card cage.
Push the ejector levers to their closed position and tighten the captive screws on each
side of the card, securing the MPM/MPM+/MPMx card to the RMX.
The blue HS LEDs on the MPM/MPM+/MPMx card and the Control Unit start flashing
and the power on cycle for the card is initiated:
— The card's resources are added to the system resources list
— The number of available resources on the RMX is usually increased to the current
CFS license level
— Port usage is re-calculated and the Port Gauges and Video/Voice Port Configuration
are updated
When the power on cycle of the MPM/MPM+/MPMx card is completed, the blue HS
LEDs will turn OFF. The green RDY LED on the MPM/MPM+/MPMx card switches on
and remains lit.
Ensure that the power switch on the RMX 2000 is turned OFF (O).
Unscrew the captive screws on the rear panel of the RMX 2000 that secure the RTM IP
card.
Polycom, Inc.
Advertisement
Table of Contents
