Installing The Replacement Mpmx/Mpmrx Card; Installing A New Mpmx/Mpmrx Card In A Powered On Rmx 2000 - Polycom 2000 Hardware Manual

RealPresence®Collaboration Server (RMX) 2000 Hardware Guide
 Port usage is re-calculated and the Port Gauges and the Video Port Configuration dialog boxes
are updated.
4 When the blue HS LEDs on the MPMx/MPMRx, RTM ISDN and Control Unit stop flashing and
remain lit, unscrew the captive screws and move the ejector levers to their fully open position and
remove the MPMx/MPMRx card.
5 Carefully slide the MPMx/MPMRx card out through the front panel.
.

Installing the Replacement MPMx/MPMRx Card

If only one media card is installed in the system, it must be inserted in the top slot of the RMX chassis.
To install a replacement MPMx/MPMRx Card:
1 On the card to be installed, move the ejector levers to their fully open position.
2 Slide in the replacement MPMx/MPMRx card.
3 Push the MPMx/MPMRx card firmly into the Backplane, making sure it is properly seated in its slot.
4 Ensure that the metal ejector levers are fully retracted into their housings.
5 Tighten the captive screws on the front panel of the RMX that secure the MPMx/MPMRx card to the
chassis.

Installing a New MPMx/MPMRx Card in a Powered On RMX 2000

If only one media card is installed in the system, it must be inserted in the top slot of the RMX chassis.
To install a new MPMx/MPMRx card in a powered on RMX 2000:
1 If applicable, loosen the captive screws and remove the slot cover.
2 On the card to be installed, move the ejector levers to their full open position.
3 Insert the card into the slot until the ejector levers touch the front edge of the card cage.
4 Push the ejector levers to their closed position and tighten the captive screws on each side of the
card, securing the MPMx/MPMRx card to the RMX.
The blue HS LEDs on the MPMx/MPMRx card and the Control Unit start flashing and the power on
cycle for the card is initiated:
 The card's resources are added to the system resources list.
Polycom, Inc. 46