Replace The Power Supply Module - Polycom RMX 2000 Hardware Manual

RealPresence Collaboration Server (RMX) 2000 Components and Components Replacement

Replace the Power Supply Module

A single supply unit powers the RMX 2000. Use the following procedure to replace a Power Supply.
Warning: Verify power supply type
Please verify the type of power supply used on your RMX 2000. Do not insert a different type of
power supply than the type currently installed on your system.
To replace the Power Supply Module:
1 Ensure that the power switch on the RMX 2000 is turned OFF (O) and that the power cords are
disconnected from the MCU.
2 Unscrew the captive screws on the front panel of the RMX 2000 that secure the Power Supply unit.
3 Use the finger grip to pull the Power Supply unit out of its slot in the Backplane.
4 Carefully slide the Power Supply unit out through the front panel.
5 Slide in the replacement Power Supply unit.
6 Push the Power Supply unit firmly into the Backplane, making sure it is properly seated in its slot.
7 Tighten the captive screws on the front panel of the RMX 2000 that secure the Power Supply unit.
8 Turn ON the RMX 2000.
.
Note: MPMRx card mode
For more information on the Card Configuration Modes after reset, see
Server (RMX) 2000 Rear
Polycom, Inc.
Panel.
RealPresence Collaboration
52