Polycom RMX 2000 Hardware Manual page 35

RealPresence Collaboration Server (RMX) 2000 Components and Components Replacement
The following table provides descriptions of each component.
RMX 2000 Component Description
Component
CNTL (CPU) Module
Power Supply Drawer
Fan Drawer
Multi Processor Module
(MPMRx) Card
Polycom, Inc.
Description
The CNTL module controls and manages the RMX 2000. The CNTL module has
a ComExpress Intel i3 Processor, a 64GB Half Slim SSD and 8Gb DDR RAM.
The Operating System is Linux.
The Power Supply drawer is located below the MPMRx Cards and is connected
to the backplane by means of a power connector. It operates at 100-240 volts AC
50/60 Hz, and provides +48VDC 1KW output with built-in load sharing
capabilities.
Three fans are mounted sideways in a drawer. Airflow is from right to left, and out
the side of the MCU. The drawer is connected to the Back-plane by a connector.
The MPMRx cards, perform the various RTP, audio and video processing
functions on the RMX 2000 unit. TI processors are at the core of each MPMRx
card which are available in two assemblies:
• MPMRx -S
• MPMRx -D
Notes:
• An MPMRx card on the front of the RMX must always be seated or connected
opposite to either an RTM LAN or RTM ISDN card on the rear of the chassis.
• The MPMRx card(s) can only work with software version 8.3 or later. Ensure
that software appropriate to the MCU hardware configuration is installed in the
MCU.
• The MPMRx card can work only with a new environmentally friendly D or
E-type chassis and is disabled when inserted in a C-type chassis.
For more details about the chassis types, see
Server (RMX) Chassis Types.
• G.719 audio algorithm is not supported with MPMRx cards.
RealPresence Collaboration
35