Install Or Replace The Rtm Isdn Card; Remove The Blank Cover; Remove An Existing Rtm Isdn Card; Install A New Or Replacement Rtm Isdn Card - Polycom RMX 2000 Hardware Manual

RealPresence Collaboration Server (RMX) 2000 Components and Components Replacement

Install or Replace the RTM ISDN Card

As a first installation, the RTM ISDN card must be installed in the top slot of the RMX chassis. The RTM
ISDN card must be seated opposite to an MPMRx card located in the top slot on the front of the RMX.
Prior to adding the RTM ISDN card you must have your ISDN product license available. For more
information, see First Entry Power-up and Configuration in the RealPresence Collaboration Server (RMX)
1800/2000/4000 Getting Started Guide.

Remove the Blank Cover

For details, see Remove the Blank Cover from the Rear

Remove an Existing RTM ISDN Card

Carry out the following procedures to remove an existing RTM ISDN card.
To remove an existing RTM ISDN card:
1 Ensure that the power switch on the RMX 2000 is turned OFF (O).
2 Unscrew the captive screws that fasten the card to the MCU. Use the metal ejector levers to pull the
card out of its slot from the backplane.
3 Slide out the RTM ISDN card.

Install a New or Replacement RTM ISDN Card

Carry out the following procedure to install a new RTM ISDN card or replace an existing one.
To install a new or replacement RTM ISDN card:
1 On the new RTM ISDN card move the ejector levers to their fully open position.Slide in the RTM
ISDN card in the RMX slot.
Note: RTM ISDN card and MPMRx card
An RTM ISDN card must connect directly to an MPMRx card in the opposite facing front slot.
2 Push the card into the slot until the ejector levers touch the front edge of the card cage.
Polycom, Inc.
Panel.
58