Using Custom Test Image Packs - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
3. Select the 3D mode (Side-by-Side, Top-and-Bottom or Frame Packing) and then select the subtype and Left/Right
options (if applicable).
4. Select the 3D bitmap image or test pattern from the Test Pattern list (see screen example below). Refer to the section:
List of Test Patterns
Note: When rendering bitmaps, you will have to make sure that the 3D bitmap you use matches your selection of 3D
formats and timing (resolution). In the example above, a 3D Frame Packing bitmap is selected for 1280 x 720. Therefore
you have to make sure that you select that specific timing (i.e. 1280 x 720) and that specific 3D format structure (Frame
Packing).
7.6

Using Custom Test Image Packs

The 804/804A/804B provides licensed image packs for certain sets of test images. You need to have a license key to use
these custom test image packs. You can arrange to get access to them by contacting Quantum Data customer support at:
http://www.quantumdata.com/support.
When you purchase an image pack it appears as an icon at the end of the list of Test Patterns. A sample screen is shown
below (Philips1, ChinaRes, Master). You simply select one of the test patterns (e.g. ChinaRes in the screen example below).
They will take a few seconds to load. They will load at the resolution of the format that you have selected.
Page 35
for a complete list of 3D test patterns.
Revision B3