Creating Custom Menus - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
10

Creating Custom Menus

This section describes how to configure custom menus on the . Custom menus enable you to
804/804A/804B
display a menu of commonly used functions on the touch display. This allows you to save time by
804/804A/804B
quickly executing a specific set of resolution and image combinations.
The custom menus are setup using two text files that you create on your PC and transfer over to the
. The two files are: 1) UserKeys.txt and 2) SeqMap.txt. The UserKeys.txt is a set of commands with
804/804A/804B
menu key codes. Each set of commands is a line in the text file.
10.1.1 To create a custom menu:
Use the following procedure to create a custom menu on your .
804/804A/804B
1. Create a UserKeys.txt file or edit an existing file. An example of a UserKeys.txt file is shown below.
#F0 fmtl 720p60;imgl user01;fmtu
#F1 fmtl 1080p60;imgl pgcwrgb;fmtu
#F2 fmtl 480p60;imgl smptebar;fmtu
#F3 fmtl dmt0660;imgl ramp;fmtu
#F4 fmtl 1080i30;imgl focus;fmtu
#FF mfgm 0
Note that the commands are separated by a semicolon. In the example above in the first line there is a custom
bitmap image "user01" that is used.
2. Create a SeqMap.txt file or edit an existing file. An example of a SeqMap.txt file is shown below.
The SeqMap.txt then maps the commands listed in the UserKeys.txt file to a name and a location on the custom
menu. The following is an example of a SeqMap.txt file.
#F0 720p Master
#F1 1080p PGCWrgb
#F2 480p SMPTEbar
#F3 DMT0660 Ramp
#F4 1080i Focus
#FF Go Home
The result of these two files would be the following custom menu:
Page 47 Revision B3