Rendering 3D Test Patterns On An Hdtv - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
IMGU // applies the image
ICHS // save the bitmap into cache
Note: Whenever you load these bitmap images either from the front panel or the command line they will be loaded from
cache and will be rendered on the display more quickly. But it is important to understand that each bitmap image is
specific to a particular format resolution. Therefore, you will have to select the bitmap such that it is consistent with the
resolution of the format that is active.
7.5

Rendering 3D Test Patterns on an HDTV

This subsection describes how to render 3D test patterns and bitmaps on an HDTV. The 804/804A/804B supports Side-by-
Side, Top-and-Bottom and Frame Packing (for both interlaced and progressive timings) 3D format structures. You can render
bitmaps that you have or create or you can render 3D test patterns in the 804/804A/804B test pattern library.
You can obtain 3D bitmaps in three ways:

Develop your own 3D bitmaps.

Sample 3D bitmaps from the Quantum Data website (www.quantumdata.com/downloads).

Generate 3D bitmaps from your own stereoscopic image pairs using the Quantum Data 3D Bitmap Conversion Tool
available from the Quantum Data website (www.quantumdata.com/downloads).

Once you have the 3D bitmaps you can transfer them to the 804/804A/804B using the procedures described in the
section Importing Custom
Use the following procedures to render 3D Bitmaps or 3D Test Patterns on HDMI Sink Device.
1. Select a format that is suitable for rendering 3D images such as 720p60 and 1080. Use the procedures above in the
section Procedures for Selecting an HDMI Resolution and Frame
If you have used the Quantum Data 3D Bitmap Conversion Tool, there is a naming convention for the 3D bitmaps which
also provides the required format for each specific bitmap.
2. Touch select 3D Output option from the top level menu shown below.
The following screen will appear:
Page 34
Bitmaps.
Rate.
Revision B3