Programming A Test Sequence In The Userkeys File - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
NEXT
TIMING
352 // 1080p60 HDMI
PATTERN
100 // ramp
END // press the END key to halt the of sequence programming
4.
Play back a sequence as follows.
OUT
001
NEXT
NEXT
(repeat NEXT or PREVIOUS)
13.7

Programming a Test Sequence in the UserKeys file

You can also create a test sequence by including a set of commands in the UserKeys.txt file. The UserKeys.txt file is primarily
used internally for mapping the keypad keys to a set of commands for general keypad use. However you can also use the
UserKeys.txt file to store programming test sequences similar to macros.
The following is an example of a UserKeys.txt file which shows the keypad mapping and more importantly a test sequence
instruction set (#F0, #F1 and #FF). Note that there are two macro test sequences defined #F0 and #F1. The #FF definition is
a macro that simply disables manufacturing mode in the 804 test instrument. The #F0 macro also shows a special use case
for the kbrd command. In this case the kbrd f0 command will cause the macro to loop back on itself such that the #F0 macro
continuously loops.
Note: Do not change any of the keypad mapping commands. These are the commands such as xkpm, xkpkj, xkpu, xkpi.
Modifying these commands will affect the general functions of the keypad.
S xkpm 2
T xkpm 1
U xkpm 4
V xkpj 1
W xkpj -1
X xkpu
Y xkpi 1
Z xkpi 2
[ xkpi 3
\ xkpi 4
] xkpi 5
^ xkpi 6
_ xkpi 7
` xkpi 8
a xkpi 9
Page 72 Revision B3