Teledyne 804A User Manual page 51

804 Series Video Test Generator – User Guide
Table 11-1: Audio Signal Type
Audio Format Audio Interface
Supported on the
DTS-ES 6.1
following interfaces:

Supported on the
DTS HD HRA
following interfaces:

Supported on the
DTS-HD Master
Audio following interfaces:

Page 51
Audio Test Tone Description
Provides a set of DTS 6.1 noise patterns:
500-2kHz Pink

HDMI
20-20kHz Pink

Impulse

 Polarity
 Auto Time Delay (no options)
Provides a set of DTS 6.1 sine waves:
 Sine Wave
Provides a set of DTS-HD Hi Bit Rate sine wave
clips:
HDMI  192kHz 7.1 5376kb HDHRA – 8 channel @
192kHz sampling rate
192kHz 5.1 3840kb HDHRA – 6 channel @

192kHz sampling rate
192kHz 7.1 5760kb HDHRA – 8 channel @

192kHz sampling rate
Provides a set of DTS HD Master Audio sine wave
clips:
HDMI  5.1 192kHz – 6 channel @ 192kHz sampling
rate
7.1 192kHz – 8 channel @ 192kHz sampling

rate
Audio Test Tone Options
Channel Selection (gating control):
 L – turn left channel on
C – turn center channel on

 R – turn right channel on
LFE – turn low frequency effects

channel on
 Rs – turn right surround channel on
Ls – turn left surround channel on

Cs – turn center surround channel on

 All – turn all channels on
Cycle – cycle through all channels in

sequence; 8 seconds per channel
Channel control:
 63Hz
125Hz

1kHz

 4kHz
For frequency you can select:
Cycle – cycle through all channels in

sequence; 8 seconds per channel
All – turn all channels on

Not applicable
Not applicable
Revision B3